increasing drillpress size
increasing drillpress size
hi all new on here was wondering if I could increase the column size on a bench top DP USING SCAFFOLD TUBE IF ITS RIGHT DIAMETER
-
promhandicam
- Moderator
- Posts: 3150
- Joined: Wed Oct 17, 2007 8:50 am
- Location: Surrey
- Contact:
Re: increasing drillpress size
Welcome to the forum. In answer to your question, if the scaffold tube is the same diameter then it should work although as scaffold tube is galvanised the surface won't be smooth so take care in making sure the table is locked tightly in place especially if you're putting something heavy on it.
Steve
http://www.allford.co.uk
http://www.allford.co.uk
-
9fingers
- Subscriber
- Posts: 955
- Joined: Tue Oct 23, 2007 12:27 pm
- Location: Romsey, Hampshire UK
- Contact:
Re: increasing drillpress size
Scaffold tube is 1-29/32" diameter ( it is a historic thing) and that is going to be much smaller than anything but a toy pillar drill is going to need.
the wall thickness is a bit thin so will flex quite a lot.
Bob
the wall thickness is a bit thin so will flex quite a lot.
Bob
Information on induction motors and inverters here
https://drive.google.com/file/d/0B_GZrX ... sp=sharing" onclick="window.open(this.href);return false;
https://drive.google.com/file/d/0B_GZrX ... sp=sharing" onclick="window.open(this.href);return false;
Re: increasing drillpress size
thanks for the tip think I will go for new floorstanding one
Return to “Power Tools and Machinery”
Who is online
Users browsing this forum: No registered users and 2 guests